Takstar WTG-500R

The receiver, to create a set of tour guide for simultaneous translation, or language of the conference.

In a set with one transmitter can be operated from one to 50pcs receivers.

PLL frequency synthesizing method for stable transmission signal.

UHF frequency range from 6 selected channels.

The design with low power consumption, the receiver can operate more than 24 hours with 2 units. AA batteries.

The dynamic expansion scheme for S / N ratio high.

The transmitters and receivers used for the LCD display frequency, channel, battery level status.

Stable radio coverage area up to 100 m.

Takstar WTG-500R — Wireless Tour Guide Receiver for Guided Tours, Museums and Simultaneous Interpretation

Takstar WTG-500R is a professional wireless UHF receiver designed for the Takstar WTG-500 tour guide system. It enables individual listeners to receive spoken commentary from a tour guide, lecturer, interpreter or presenter.

The receiver is intended to expand an existing wireless tour guide system, allowing additional participants to receive the same audio transmission without purchasing a separate transmitter for each listener.

WTG-500R operates as part of a system using the 780–789 MHz UHF band, supports 6 selectable channels, features an LCD display and uses two 1.5 V AA batteries.

Its low-power design provides more than 24 hours of receiver operation under the conditions specified by the manufacturer.

Important: Takstar WTG-500R is a standalone receiver, not a complete wireless tour guide kit. A compatible Takstar WTG-500 transmitter is required and must be purchased separately.

Key Benefits of Takstar WTG-500R

• Additional wireless receiver for the WTG-500 tour guide system.
• Enables more listeners to join an existing guided tour group.
• 780–789 MHz UHF operating band.
• Six selectable channels.
• PLL frequency synthesis within the compatible system.
• LCD display showing frequency, channel and battery status.
• More than 24 hours of receiver operation.
• Power supplied by two replaceable AA batteries.
• Manufacturer-specified system range exceeding 100 m under appropriate conditions.
• Suitable for guided tours, museums, training and interpretation.
• Convenient system expansion without replacing existing equipment.

Additional Receiver for Expanding a Tour Guide System

The primary purpose of Takstar WTG-500R is to increase the number of listeners who can receive audio from a compatible WTG-500 transmitter.

One tour guide uses the transmitter, while participants listen through individual receivers.

This approach allows tour operators, museums and event organizers to expand their equipment gradually as visitor numbers increase.

ClubTech lists support for one to 50 receivers with a single transmitter. Before building larger systems, compatibility of the specific frequency version and the manufacturer's recommendations should be verified.

Wireless Receiver for Guided City Tours

Takstar WTG-500R is suitable for walking tours through historic city centers, tourist routes, architectural landmarks and cultural attractions throughout Ukraine.

The guide uses a compatible transmitter and microphone, while participants receive spoken commentary through personal receivers.

This arrangement is useful during guided tours in Kyiv, Lviv, Odesa, Chernivtsi, Kamianets-Podilskyi and other destinations where background noise may affect speech intelligibility.

Individual listening helps participants follow the guide's explanations while the group moves along the tour route.

For Museums, Galleries and Exhibition Centers

Museums need to provide clear explanations without disturbing other visitors.

Takstar WTG-500R allows individual listening through a compatible wireless tour guide system.

The receiver is suitable for themed museum programs, historical exhibitions, exhibit presentations and organized group visits.

Additional receivers are especially useful for venues where tour group sizes change according to the season and event schedule.

For Factory Tours and Industrial Facilities

Takstar WTG-500R can be used during guided visits to factories, manufacturing facilities, logistics centers, warehouses and other industrial locations.

In large spaces with background noise, visitors may find it difficult to hear the tour leader.

A personal receiver allows participants to receive spoken information through a compatible wireless system when reliable radio reception is available.

The equipment is useful for delegation visits, production process presentations and educational facility tours.

Important: The receiver is not hearing protection equipment and does not replace mandatory personal protective equipment in industrial environments.

For Simultaneous Interpretation and International Conferences

The Takstar WTG-500 system is intended not only for guided tours but also for spoken interpretation.

An interpreter uses a microphone and transmitter, while participants listen through individual WTG-500R receivers.

This is useful for international conferences, business meetings, forums, seminars and visits by foreign delegations.

Six selectable channels allow separate transmission systems to be configured. Multilingual events require proper frequency planning and confirmation that the intended number of systems can operate simultaneously.

Takstar WTG-500R does not translate speech automatically. The receiver reproduces audio transmitted by an interpreter through a compatible transmitter.

For Staff Training, Lectures and Presentations

Takstar WTG-500R is suitable for educational tours, practical demonstrations, off-site lessons and corporate training.

Teachers or instructors use a compatible transmitter, while participants receive explanations through individual receivers.

This is convenient when groups move between training areas, demonstration stations and exhibition displays.

780–789 MHz UHF Band and PLL Technology

Takstar WTG-500R operates within a system using the 780–789 MHz UHF band and supporting 6 selectable channels.

PLL frequency synthesis supports stable generation of the system's operating frequency.

The manufacturer also describes a dynamic expanding circuit designed to maintain a high signal-to-noise ratio.

Actual reception quality depends on local RF conditions, interference, distance from the transmitter and the operating environment.

Six Channels for Multiple Tour Groups

Six selectable channels allow operators to configure transmitters and receivers according to the needs of an event.

This is useful for museums, tour operators and conference organizers conducting several activities at the same venue.

Simultaneous operation of independent groups requires proper frequency allocation and verification of interference conditions.

Wireless Range Exceeding 100 Meters

The official WTG-500 technical specification table lists an operating range of more than 100 meters.

Actual range may vary due to walls, metal structures, transmitter placement and radio-frequency interference.

For professional tours, the communication range should be checked at the actual event location.

LCD Display for Convenient Operation

The Takstar WTG-500R receiver features an LCD display showing the operating frequency, selected channel and battery status.

This helps operators check equipment settings before a tour and monitor battery status during use.

More Than 24 Hours of Battery Operation

Takstar WTG-500R uses two 1.5 V AA alkaline batteries.

Its low-power design provides more than 24 hours of receiver operation, according to the manufacturer.

Replaceable batteries are convenient for tour operators, museums and event organizers because depleted batteries can be exchanged quickly.

Actual battery life depends on battery quality and operating conditions.

Takstar WTG-500R Technical Specifications

• Model: Takstar WTG-500R.
• Product type: additional wireless UHF tour guide receiver.
• Compatible system: Takstar WTG-500.
• System operating frequency: 780–789 MHz.
• Number of channels: 6.
• System frequency synthesis: PLL.
• System frequency response: 30 Hz–15 kHz.
• Receiver sensitivity: 3 μV at 12 dB S/N.
• System signal-to-noise ratio: ≥50 dB.
• System operating range: more than 100 m according to the official specification table.
• Receiver power supply: 2 × 1.5 V AA batteries.
• Receiver operating time: more than 24 hours.
• Display: LCD.
• Display information: frequency, channel and battery status.
• Applications: guided tours, interpretation and audiovisual education.

Operating frequency, range and audio specifications refer to the compatible WTG-500 system.

Takstar WTG-500R Package Contents

This product listing is for one standalone Takstar WTG-500R receiver.

The inclusion of an earphone, batteries or other accessories should be confirmed against the actual supplied package.

A Takstar WTG-500 transmitter is not included with this product.

Benefits for Tour Operators and Event Organizers

Purchasing additional WTG-500R receivers allows an existing tour guide system to be expanded according to the number of participants.

This helps organizations build appropriate equipment sets for guided tours, museum programs, international events and corporate presentations.

The system is suitable for organizations that need individual speech listening and gradual expansion of receiver capacity.

Important for Ukraine: Before operating equipment in the 780–789 MHz band, verify that the specific frequency version complies with applicable Ukrainian radio-frequency requirements.

ClubTech — Direct Takstar Importer in Ukraine

ClubTech is a direct importer of Takstar products in Ukraine. We supply genuine wireless tour guide systems, transmitters, receivers, microphones, wireless audio systems and other professional sound equipment.

We serve tour operators, museums, travel agencies, businesses, conference organizers, installation companies and individual customers.

We offer retail and wholesale sales and welcome cooperation with new customers and business partners.

We invite new dealers, musical and professional audio retailers, entrepreneurs, tourism companies, system integrators, installation contractors and companies involved in professional audio equipment sales, design and installation.

For dealers, wholesale customers and installation companies, we offer special favorable cooperation terms, individual commercial proposals and long-term partnership opportunities.

 FAQ

1. What is the Takstar WTG-500R receiver used for?

Takstar WTG-500R is an additional wireless receiver for the Takstar WTG-500 tour guide system. It allows individuals to listen to speech from a tour guide, lecturer or interpreter during guided tours, presentations and conferences.

2. Can Takstar WTG-500R operate without a transmitter?

No. A compatible Takstar WTG-500 transmitter is required. The WTG-500R receiver cannot transmit audio independently and is not a complete tour guide system.

3. How many WTG-500R receivers can work with one transmitter?

ClubTech's product information states that one WTG-500 transmitter can be used with 1 to 50 receivers. Before configuring a larger system, confirm frequency-version compatibility and the intended equipment configuration.

4. What batteries does Takstar WTG-500R use, and how long does it operate?

The receiver uses two 1.5 V AA alkaline batteries. The manufacturer specifies more than 24 hours of receiver operation. Actual battery life depends on battery quality and operating conditions.

5. Where can I buy Takstar WTG-500R receivers wholesale in Ukraine?

ClubTech is a direct importer of Takstar products in Ukraine. We offer wholesale and retail sales and welcome cooperation with tour operators, museums, musical equipment retailers, installation companies, system integrators and new dealers under special favorable business terms.

ClubTech welcomes new customers and dealers interested in cooperation throughout Ukraine.

& nbsp;